GE Monogram ZW9000SJSS Manual de usuario

Installation InstructionsZJ7000 and ZW9000Electric Warming Drawer12-14 GEmonogram.com31-10700-5Printed in the United States

10TOOL AND MATERIALS REQUIRED• Safety Glasses• Phillips screwdriver• Drill and appropriate bits (Brad point recommended for drilling through wood p

11 SECURE CUSTOM PANEL TO METAL MOUNTING PANEL• Lay the custom panel, appearance side down, on a clean surface.• Remove all tape and packing mater

12 REMOVE ORIGINAL DRAWER FRONT• Remove the three screws from the bottom of the drawer edge.• Remove the four screws on the inside of the drawer at

13Notes

Notes14

Notes15

NOTE: While performing installations described in this book, safety glasses or goggles should be worn.For Monogram® local service in your area, call

2BEFORE YOU BEGIN Read these instructions completely and carefully.• IMPORTANT³ Save these instructions for local inspector’s use. • IMPORTANT³ O

CONTENTSDesign InformationModels Available ...3Accessories ...

4PRODUCT DIMENSIONS AND CLEARANCESDesign Information9”10-1/2”ABC1”Including HandleDrawer Open23-1/4”Dimensions A B C ZW9000 22” 26” 30” ZW9000 w/ZX

Design Information5GROUNDING THE APPLIANCEPlease read carefully. Do not use an extension cord or adapter plug with this appliance. Follow National ele

6Installation PreparationTOOLS REQUIREDSafety GlassesCut Resistant GlovesDrill and 1/16” BitMeasuring TapePhillips ScrewdriverHand SawMATERIALS REQUI

7Installation PreparationNOTE: Additional clearance between cutouts may be required. Check to be sure that oven supports above the Warming Drawer lo

8Installation PreparationINSTALLATION BELOW A COUNTERTOP*NOTE: When installing the warming drawer below a cooktop, a solid barrier must be installed a

WARNINGANTI-TIP PRECAUTIONSAn anti-tip brace must be installed to prevent the drawer from tipping forward when opened and loaded. Failure to do so cou